General
Height	60 mm
Width	150 mm
Length	2000 mm
Useful cross section	7000
Material	Steel
Material quality	Other
Surface protection	Continuously galvanized
Colour	Zinc
Number of permanent partitions	0
Number of plug-in partitions	2
Type of fastening	Bottom perforation
Cover model	Loose
Degree of protection (IP)	IP30
Impact strength	IK08
Working temperature	90
Halogen free
Suitable for circuit integrity
Transparent
With cable fixing clip
With protection film
With duct connector
Delivery on roll
Pre-stamping
Antibacterial treatment

Cable routing duct made of sheet steel LFS 60x150mm galvanized. Electrical installation duct system Cable routing duct made of sheet steel in accordance with DIN EN 50085-1 for laying cables. Duct bottom/top with pre-punched holes in the bottom at 250 mm intervals. Couplings for the equipotential bonding of the duct bottoms and for simple and precise duct connections. Installation in a partition wall is possible. If installed overhead, the duct must be mounted with sheet steel clamps.
Note: Equipotential bonding, earthing, soundproofing and fire protection measures must be carried out professionally.