General
Mounting method	Floor installation
Type of cover	Door
Cover model	With notch
Type of door	Double
Nominal current (In)	1600 A
Height	1900 mm
Width	610 mm
Depth	400 mm
Built-in depth	400 mm
Internal depth	400 mm
Plate thickness cabinet	2 mm
Plate thickness door/cover	2 mm
Colour	Grey
RAL-number	7035
Number of modules	288
Number of rows	12
Width in number of modular spacings	24
Number of openings for flange plates	4
Number of conduit inlets	4
Material housing	Steel/Plastic
Surface protection	Powder coating
Degree of protection (IP)	IP54
Protection class	II
Impact strength	IK10
Circuit integrity	None
Transparent cover/door
With lock
Extension possible
With mounting plate
Suitable for outdoor use
Suitable for lightning protection

Modular cabinet, universal, IP 54, protection class II, 1900x610x400 mm. Modular cabinet for indoor installation in accordance with VDE 0660 Part 600-1/-2, DIN EN 61 439-1/-2, dimensions in accordance with DIN 43870, protection class IP 54 in accordance with DIN EN60529 (VDE0470-1), protection class IP 3x with open door, air and creepage distances in accordance with VDE 0110, Part 1 and 2/1.89, rated insulation voltage AC 800 V, overvoltage category IV, pollution degree 3, protection class II. Floor-standing housing for single or row installation with removable rear and side panels, width 1 to 6 fields, 144 to 864 space units. Interior fitting system can be installed for network systems: 3 AC 50 Hz 230/400 V or 3 AC 50 Hz 400/690 V with a maximum feed-in current of 1600 A.
Cabinet frame made of glass-fiber reinforced plastic, cover plate and rear wall made of hot-dip galvanized sheet steel. With horizontal support rail for supporting rail stabilization, coupling plates for supporting rail fastening, prepared for univers N interior fitting system. Busbar bushing can be flanged next to each other through open side walls. Door made of sheet steel, powder-coated and baked, surface-mounted with internal hinges, can be hinged on the right or left. Door opening angle 120°, double door from width 1100 mm, door lock with standard four-point rod lock (single door) or 3-point rod lock (two doors) with 3 mm double bit.
Upper cable entries: 2 rows are punched out in the cover plate for each field, different cable entries can be installed. Lower cable entries: open, base plate can be installed. Compliance with the protection class is required for installation of the cable entries at the top/bottom.
Note: The installation of a baseboard (100 mm or 200 mm) is always required (accessory)! Matching side walls are available as accessories. Door lock can be exchanged for other locks