General
Model	Movement sensor
Scan angle	360 °
Optimum mounting height	2.5 m
Max. transmission range sideways	10 m
Max. transmission range frontally	5 m
Mounting method	Flush mounted (plaster)
Connection type	Plug clamp
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Matt
Colour	White
RAL-number (akin)	9010
Degree of protection (IP)	IP20
Impact strength	IK04
Voltage type	AC
Frequency	60 Hz
Min. switch-on time	2 s
Max. duty cycle	60 min
Switch-off delay	0 s
Switching-on delay	0 s
Detection angle horizontal	360 °
Pivoting range sensor, horizontal	0 °
Pivoting range sensor, vertical	0 °
Response value luminosity	2000 lx
Max. switching power	2000 W
Height	76 mm
Depth	75.9 mm
Diameter	85 mm
Built-in width	0 mm
Built-in depth	78 mm
Built-in length	0 mm
Built-in diameter	68 mm
Min. depth of built-in installation box	0 mm
Constant light control
HVAC-control
Forced switch on
Forced switch off
Animal zone
Creep-under protection
Networkable
Staircase monitoring
Bridging switch
Suitable for wireless transmission
Remote operation
With remote control
Response value sensitivity adjustable
Response value luminosity adjustable
With signal unit
Teach-function for response value luminosity
Suitable for ceiling mounting
Dim function with dimmer basic element
Halogen free
Antibacterial treatment
Suitable for C-load
Substation input
IFTTT support available
With connection cable

Motion detector corridor 360°, built-in, normally open contact, detection 30x5m. Motion detector built-in for automatic switching of electrical loads, depending on heat movement/ambient brightness and is suitable for installation in cavity mounting in ceilings indoors. Especially suitable for detecting movement in corridors and long hallways.
Main functions: adjustable response brightness and daylight control, adjustable follow-up time, master/slave function.
Note: An optional IR hand-held transmitter can control different operating modes (e.g. on/off).