General
Model	Presence detector
Scan angle	360 °
Optimum mounting height	4 m
Max. transmission range sideways	6 m
Max. presence range	20 m²
Max. transmission range frontally	7 m
Mounting method	Flush mounted (plaster)
Connection type	Screwed terminal
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Matt
Colour	White
RAL-number (akin)	9001
Degree of protection (IP)	IP41
Impact strength	IK03
Voltage type	AC
Frequency	60 Hz
Min. switch-on time	60 s
Max. duty cycle	60 min
Switch-off delay	0 s
Switching-on delay	0 s
Detection angle horizontal	360 °
Pivoting range sensor, horizontal	360
Response value luminosity	1000 lx
Max. switching power	2300 W
Number of switching zones	1
Max. starting current	16 A
Min. starting current	0 A
Width	80 mm
Height	75 mm
Depth	70 mm
Diameter	80 mm
Built-in width	0 mm
Built-in depth	70 mm
Built-in length	0 mm
Built-in diameter	68 mm
Min. depth of built-in installation box	75 mm
Nominal voltage	230 V
Constant light control
HVAC-control
Forced switch on
Forced switch off
Animal zone
Creep-under protection
Networkable
Staircase monitoring
Bridging switch
Suitable for wireless transmission
Remote operation
With remote control
Response value sensitivity adjustable
Response value luminosity adjustable
With signal unit
Teach-function for response value luminosity
Suitable for ceiling mounting
Dim function with dimmer basic element
Halogen free
Antibacterial treatment
Suitable for C-load
Substation input
IFTTT support available
With connection cable

Presence detector installation 360° On/Off. Presence detector with ON/OFF function for lighting control in commercial buildings and residential houses, by detecting moving people. For installation in hollow walls or suspended ceilings with a detection range of 7m in diameter at a mounting height of 2.5m. Basic setting directly on the already installed device without dismantling possible or optionally via the remote control EE807. Selection of different operating modes, such as semi-automatic/automatic/learning/day/corridor/office/test mode. Setting of two modes in the event of a power interruption, as well as active/passive switching to activate or deactivate the light threshold in the respective detection cell. On/off switching via button or optionally available remote control EE808 also possible.