General
Model	Movement sensor
Scan angle	360 °
Optimum mounting height	4 m
Max. transmission range sideways	6 m
Max. presence range	12.5 m²
Max. transmission range frontally	6 m
Mounting method	Surface mounted (plaster)
Connection type	Screwed terminal
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Matt
Colour	White
RAL-number (akin)	9001
Degree of protection (IP)	IP21
Impact strength	IK04
Voltage type	AC
Frequency	60 Hz
Min. switch-on time	5 s
Max. duty cycle	30 min
Switch-off delay	0 s
Switching-on delay	0 s
Detection angle horizontal	360 °
Pivoting range sensor, horizontal	360
Response value luminosity	1000 lx
Max. switching power	2300 W
Number of switching zones	1
Max. starting current	10 A
Min. starting current	0 A
Width	100 mm
Height	61 mm
Depth	100 mm
Diameter	100 mm
Built-in width	0 mm
Built-in depth	0 mm
Built-in length	0 mm
Built-in diameter	0 mm
Min. depth of built-in installation box	0 mm
Constant light control
HVAC-control
Forced switch on
Forced switch off
Animal zone
Creep-under protection
Networkable
Staircase monitoring
Bridging switch
Suitable for wireless transmission
Remote operation
With remote control
Response value sensitivity adjustable
Response value luminosity adjustable
With signal unit
Teach-function for response value luminosity
Suitable for ceiling mounting
Dim function with dimmer basic element
Antibacterial treatment
Suitable for C-load
Substation input
IFTTT support available
With connection cable

360° surface-mounted motion detector, normally open contact with zero-crossing circuit. 360° motion detector with increased detection sensitivity in the central presence detection area with integrated twilight switch for surface-mounted installation. For use indoors, for example: corridors, entrance halls, etc. The detector reacts to the infrared radiation (body heat) of moving bodies within a detection diameter of 6 m at a recommended installation height of 2.5 m. The signal is sent using a built-in pyroelectric sensor. The brightness value and the duty cycle are set using a potentiometer under an opening on the housing. Ready for use immediately thanks to the factory default setting. Test mode to check the function and detection range.