General
Width	170 mm
Depth	68 mm
Length	2000 mm
Number of covers	1
Cover width 1	80 mm
Cover width 2	0 mm
Cover width 3	0 mm
Material	Plastic
Material quality	Other
Surface protection	Untreated
Colour	White
RAL-number	9016
Construction rear wall (inner side)	Continuous C-profile
Number of plug-in partitions	1
Mounting method covers	Inner lying
Useful cross section	10050 mm²
Degree of protection (IP)	IP40
Impact strength	IK07
Working temperature	90 °C
Covers supplied with the product
Symmetric
Construction type rectangular
Halogen free
With protection film
With duct connector
Mounting perforation in bottom
With cable fixing clip
Antibacterial treatment

Parapet duct lower part, front-locking hfr for BRH 65x170mm, upper part 80mm vw. Duct lower part for the electrical installation duct system Parapet duct made of halogen-free plastic in accordance with DIN EN 50085-1 as a device installation duct with an upper part width of 80 mm for the installation of commercially available devices without additional panels.
Halogen-free plastic is flame-retardant and does not develop corrosive fire gases in combination with moisture, e.g. fire-fighting water. This means that electronic devices and material assets are better protected.
With base perforation (drill tolerance compensation on all sides) for direct wall mounting and additional rectangular perforation for tool-free fastening of the duct using clip technology on consoles. With front-locking, tool-free device installation for fastening devices and device installation boxes with quick fastening. Additional C-profile as device installation option. Couplings for simple and precise duct assembly, partition walls and cable retention clips available as accessories.
Note: Sound and fire protection measures must be carried out professionally.