KE7701 - Cable tester set and Telco line finder kit. KE7701 cable tester set and line finder kit, consisting of 2x KE7000 cable testers for detecting wiring errors in network and telecommunications cabling (RJ45, RJ11 and coax) and KE701 Telco line finder kit for identifying cables and wire pairs, with link test and network port finder. Supplied in a robust Kurth case including adapter set RJ45 to coax (Z170A) (BNC/F-Female). Cable tester set KE7000: Tests telephone (RJ11), data (RJ45) and coax cables Tests for continuity, interruption, short circuit, swapping, shielding, multiple faults Device pair shows faults on both sides Detection of active switches at the far end of the line Surge protection up to 60 V DC Cable finder kit KE301: Identification of cables and wire pairs Signal feed to active telephone and data lines Surge protection up to 120 V AC RJ45 plug, data port test and port finder function. The cable tester and cable finder kit KE7701¿ is the ideal basic equipment for all technicians when searching for cables and faults in telephone and data networks. The KE7000 are easy-to-use test devices for patch, LAN and telecommunications cabling and coaxial cables. Unshielded and shielded connecting cables with twisted pairs (UTP and STP cables) in installed networks as well as patch cables can be tested and verified. Coaxial cables with BNC and F sockets can be tested for continuity using the RJ45 coax adapter. Errors that occur, such as mix-ups, interruptions, short circuits and shielding errors, are shown on the graphic displays of the devices. The KE7000 provide clear, fast and immediately evaluable status information on both sides for cable lengths of up to approx. 150 m. The cable locator kits consist of EASYTEST and PROBE and make it possible to find any type of cable, wire and wire pair in the shortest possible time without contact. The cable finders can be used for all types of cables such as telephone cables, bell cables, data cables of all classes, coaxial cables and voltage-free electrical cables and are protected against accidental contact with external voltage surges. The KE7701 set combines two KE7000s with the KE701 Telco Kit. Like the KE301 Classic Kit, this has an RJ11 plug, two crocodile clips and a continuity test via LED. It also has an RJ45 plug for detecting active network connections and assigning the active data port on the switch, for example. A continuity test with a resistance-dependent tone enables a quick assessment of the cable condition. The KE701 Telco Kit is protected against surges of up to 120 V. KE7701¿-¿reliable, robust and cost-effective..