The forked ends allow installation in an existing trapezoid using four nVent CADDY SN nuts, saving the installer a lot of time and reducing potential downtime. Can be extended to the required length and secured with a spring clip. The top is shaped like a standard strut mounting rail, so almost all standard strut fittings can be installed along the entire length between the threaded rods. The integrated ruler shows the distance between the threaded rods in cm and inches. Supports up to seven 2' (DN 50) metal cable conduits, six 2' (DN 50) water-filled pipes at a mounting distance of 3 m, or 450 mm wide cable tray. Cable conduit can be attached to the top and bottom, replacing back-to-back welded strut mounting rails. Any pipes can be attached directly to the rail with no gap, saving space in buildings when installation space is limited.