The LAN tester allows you to easily identify the correct pin assignment of 10Base-T, 10Base-2, RJ45/TM11 modular cables as well as 258A, TIA-568A/568B and Token Ring cables, etc. by connecting the outgoing cable end to the corresponding receiving cable end is compared.
With the remote tester you can test cables that are installed in another location, for example in wall distributors or patch panels. Easy identification of the cabling is guaranteed.

Highlights

• With the cable tester you can easily check whether you have carried out your network cabling correctly and can immediately see if you have not connected an Ethernet cable correctly
• In addition to the pure continuity test, you can also test whether two wires have been swapped or not cause a short circuit
• Thanks to the remote unit, even with installation cables that have already been installed
• Depending on the situation, you can switch between the manual test and an automatic test loop test, which systematically tests one wire after the other and then starts again from the beginning
• The PoE -Tester shows you whether there is a PoE signal on a port or a network socket and which PoE mode it is
• The PoE finder is compatible with the PoE standards af < at
• The test device is for everyone Network cables from Cat-3 < coax BNC to Cat-5 < Cat-6 to Cat-7A as well as UAE, TAE < telephone cables are suitable and help, for example. B. when installing the cable for your DSL connection

Product type

• Test device
• ear category (ElektroG): relevant, Category 5: Small devices < 50 cm (all sides), small devices B2C

Basic properties

• Color: Black

Scope of delivery

• DIGITUS Network and communication cable tester, RJ45 and BNC
• remote device
• PoE test device
• 2 x BNC adapter cable
• BNC male/male adapter
• 3 x RJ45 to RJ11 adapter
• user manual
• hard case