DEHN 972115, EAN: 4013364158511

DEHN 972115 surge arrester Type 2 60 V DC

Energy > Surge Protection

DEHN 972115 surge arrester Type 2 60 V DC

Lieske Part No. 1336892
Mfg Part No 972115
EAN-Code 4013364158511
Manufacturer DEHN
Here only 181,35 EUR
215,81 EUR incl. VAT

Further information for DEHN 972115 surge arrester Type 2 60 V DC

General
SPD as per IEC 61643-41 / EN IEC 61643-41Type 2
Energy coordination with terminal equipment (≤ 10 m)type 2 + type 3
Nominal voltage (d.c.) (UN)48 V
Max. continuous operating voltage DC (UC)60 V
Nominal discharge current (8/20 µs) (In)12.5 kA
Voltage protection level (UP)≤ 0.5 kV
Response time (tA)≤ 25 ns
Short-circuit withstand capability for max. mains-side overcurrent protection (d.c.) (ISCCR)5 kA
Max. mains-side overcurrent protection63 A gG
TOV (DC), 1.5x (UT) – characteristics87 V / 5 sec. – withstand
TOV (DC), 2x (UT) – characteristics116 V / 120 min. – safe failure
Continuous current (DC) (IC)≤ 100 µA
Protective conductor current (DC) (IPE)≤ 100 µA
Protective conductor current (AC) (IPE)< 1 mA
Condition at the end of life time of the SPD AOpen Circuit Mode (OCM)
Overvoltage category (OVC) main circuitlll
Insulation between main and remote circuitDouble insulation
Operating temperature range (TU)-40 °C ... +80 °C
Operating state / fault indicationgreen / red
Number of ports1
Cross-sectional area (min.)1.5 mm2 solid / fine-stranded / 6 mm2 stranded
Cross-sectional area (max.)16 mm2 solid / 35 mm2 stranded / 25 mm2 fine-stranded
For mounting on35 mm DIN rails acc. to EN 60715
Enclosure materialthermoplastic, red, UL 94 V-0
Place of installationindoor installation
Degree of protectionIP20
Capacity1.5 Standard DIN module, DIN 43880
Type of remote signalling contactchangeover contact
Switching capacity (a.c.)250 V / 0.5 A
Switching capacity (d.c.)250 V / 0.1 A; 125 V / 0.2 A; 75 V / 0.5 A
Cross-sectional area for remote signalling terminalsmax. 1.5 mm2 solid / flexible
Extended technical data
Max. prospective short-circuit current (DC) (Ik)25 kA
Single-pole surge arrester DEHNguard SE DC, type 2 according to EN 61643-11, consisting of a base part and a plugged-in protection module. High device safety thanks to the powerful DC switching device DCD, which is specially designed for use in DC circuits. For protecting DC consumer systems against overvoltages. For use in the lightning protection zone concept at the interfaces 0B - 1 and higher.
This is an offer of:

Lieske Elektronik e.K.

Reutener Str. 10
79279 Vörstetten

https://industry-electronics.com
Tel. 07666/88499-0
Fax. 07666/88499-111

Diesen Artikel finden Sie unter:
industry-electronics.com/artikel/1336892
qrcode für DEHN 972115 surge arrester Type 2 60 V DC