Cyberdata IP Notification - SIP RGP Strobe
When installed, the wall SIP RGB Strobe works as a visual alarm device. The device can be set up as part of a ring group (call group) with strobe enabled as notification of incoming calls. The SIP RGB Strobe can also be activated by being part of a multicast group. When audio is detected on a specific multicast address and port, the strobe is activated.
Through a web page setup, you can have the SIP Strobe respond to message waiting signals by flashing. When the message has been heard, the strobe will stop flashing.
Multiple colors, flash rate and brightness can be selected for each of the different activation methods. Users can also use CyberData's HTTP command set to directly access the strobe features.
Note: Support SIP RGB Strobe with Syn-Apps devices via multicast mode.
Meets ADA requirements for telephony signaling and notification
Multiple colors, Blink rate and brightness can be selected for each of the different activation methods
Program or listen to up to 10 multicast addresses
SIP activation
Mailbox Message Waiting Indication
Multicast activation
Cisco SRST support
Event-controlled relay
Tamper sensor
Web-based setup
PoE powered