Screw punch special for heavy connectors - VA, patented die: With side ejection for the waste piece. Drilling position is pre-stamped by means of punch mandrels through the die: Punch mandrels can be replaced or turned back using a 2.5 mm hexagon key. This eliminates the need to pre-stamp the punch. Suitable for: Stainless steel (VA) and sheet steel (T 37). Operation: Hydraulic. Design: With punch, die, hydraulic screw and lock nut. Storage: In a practical, sturdy plastic case, for 16-pin connectors with the dimensions 86.0 m x 36.0 mm, pre-drill Ø 24.0 mm, max. material thickness ST37/VA: 2.0 mm