One-hand ratchet cable cutter for crush-free cutting of cables with an external diameter of max. 45 mm. Suitable for copper and aluminum cables, not suitable for steel wire, steel-armored cables and hard-drawn Cu and Bz conductors. Clean cut thanks to sharp, specially hardened blades, despite the compact design, can be operated with just one hand, saving effort thanks to the ratchet mechanism with needle-bearing eccentric transmission and ergonomic handles with a small opening width. However, the handles are long enough to use the other hand to support during peak loads. Weight only 980 g. Movable, fully pivoting blade that can be unlocked in any position, easy to replace (replacement pivoting blade - article no. 12 9168), handles locked using a rotary knob (red marking), easy opening of the cutting blades thanks to a locking pawl that can be locked in the open position. Max. cutting performance Cu (copper) max. Ø 45 mm, stranded 300 mm² / 600 mCM, sector conductor 3x70SM, AL (aluminum) max. Ø 45 mm, stranded 400 mm² / 800 MCM, sector conductor 4x70 SE