For ALL models of control modules and expansion modules
Calibration software (site license)
Calibration board - contains a set of reference resistors needed at the end of the calibration process
mDin cable for the calibration board
Resistor reference card (CB57A)
24-pin adapter cable
64-wire amp module cable
Custom banana jack cables for your Digital multimeter
Special cable for the precision capacitance decade box
Printed procedure
To perform the calibration you will also need:
A benchtop digital multimeter with a resolution of 0.01 mV at 10 V, a maximum voltage value of 1000 Vdc and 750 Vac and a calibration according to NIST/ NMAS/UKAS standards (for all kits).