General
Other bus systems	free@home
Model	Movement sensor
Mounting method	Other
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Glossy
Colour	Anthracite
RAL-number (akin)	7021
Optimum mounting height	1.1
Max. transmission range frontally	6
Detection angle vertical	19
Detection angle horizontal	180
Number of channels	1
Switching power	2300
Min. switch-on time	30
Max. duty cycle	30
Min. depth of built-in installation box	32
Built-in depth	32
Depth	56
Height	71
Width	71
Bus system KNX
Bus system KNX radio
Bus system radio frequent
Bus system LON
Bus system Powernet
Radio frequent bidirectional
Transparent
Bus connection included
Animal zone
Staircase monitoring
Response value luminosity adjustable

Motion detector/switching actuator 1-way for Busch-free@home®.
With select lens for detection with animal paths.
For automatic switching of Busch-free@home® actuators depending on movement and brightness.
The actuator's run-on time can be programmed via the web interface of the system access point.
For switching 127 V~/230 V~ consumers.
With integrated switching actuator.
Switching function is also available without prior programming (preconfigured).
Configuration can be changed later via the web interface (groups, scenes, etc.).
The bus connection is made via the included bus terminal.
When installing in the flush-mounted box, ensure that there is a spatial separation between the bus and the 127 V/230 V installation cable! If the minimum distance is not met, use electronic boxes or insulating hoses, for example.
Programming only when the bus voltage is applied via the web interface of the system access point.
Further information on commissioning and operation can be found in the system manual and the online operating manual.