Electronic room temperature controller insert heating/cooling with two normally open contacts, non-floating
Switching contact opens when the set temperature is reached
With external input for switching between heating and
cooling (230V).
Without spreader fastening
Temperature controller class: 1
Power loss (standby): <0.15W
When cooling, care must be
taken to avoid condensation on the cooled surface in high humidity (risk of thunderstorms).
The cooling should be reduced in good time or
switched off completely if necessary to avoid damage to the cooled surface.
When commissioning the temperature controller, please note that
the switching point accuracy is only achieved after approx. 1-2 hours of operation
after installation. To shorten the initial adjustment period due to moisture. To connect to hot water heating systems , control valves that are 'normally closed\lashare required for the controller .