General
Thermal feedback	Series
Control characteristic	P
Number of heater outputs	1
Differential value	0
Sensor/feeler type	Other
Mounting method	Flush mounted (plaster)
Degree of protection (IP)	IP20
Height	71
Width	71
Depth	46
Contact type	Change-over contact (NO/NC)
Measuring range	30
With receiver
External sensor
Adjustable differential
Temperature readable
With sound indicator
With display
With tap water circuit
Explosion-proof
IFTTT support available
Suitable for cooling
Suitable for heating

Electronic room temperature controller insert with changeover contact
The changeover contact is non-potential-bound The
switching contact changes when the set temperature is reached
The nominal current for the break contact is 10A
The nominal current for the make contact is 5A
Without spreader fastening
The temperature controller is class 1
Power loss (standby) <0.15W To connect to hot water heating systems , control valves that are 'normally closed\lashare required for the controller . When connecting the break contact, a control valve that is normally open is required. When commissioning the temperature controller, it should be noted that the switching point accuracy is only achieved after approx. 1-2 hours of operation after installation.