General
Mounting method	Flush mounted (plaster)
Nominal voltage	16 V
Frequency	60 Hz
Method of operation	Button
Min. depth of built-in installation box	32 mm
Width of device	71 mm
Height of device	71 mm
Depth of device	33.2 mm
Colour	Aluminium
Power consumption	0.4 W
Dimming 1-10 V
Dimming DALI
Dimming DSI
Dimming Touch and Dim
Dimming with push-button
Dimming manufacturer's proprietary system
Substation input
Light value memory
Applicable with button
Applicable with movement sensor
Applicable with presence indicator
Applicable with time switch/timer
Applicable with transmission button
Applicable with infrared button
IFTTT support available
Transparent

DALI/DSI control insert flush-mounted with integrated power supply. DALI/DSI control insert flush-mounted for DALI bus communication in broadcast mode according to IEC 62386-102, low energy consumption, automatic detection of DALI/DSI devices, remote control with KNX radio hand-held transmitters/wall transmitters in combination with KNX radio buttons, switch-on brightness can be stored in a power failure-proof manner, automatic selection of the operating mode (active/passive), supplies the system voltage for other DALI participants when the mains voltage is connected, with extension input for buttons (normally open), control information is sent centrally to all participants, with electronic short-circuit and overload protection, for switching and controlling electronic ballasts and Tronic transformers with DALI/DSI interface, no conductive connection between the support ring and spreading claws, with screw terminals. Not suitable for combination with other DALI controls.