General
Assembly arrangement	Basic element with complete housing
Model	1-pole push button
Number of poles	1
Method of operation	Rocker
Mounting method	Surface mounted (plaster)
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Matt
Type of fastening	Mounting with screw
Colour	Grey
RAL-number (akin)	7011
Suitable for degree of protection (IP)	IP55
Rated current	10
Nominal voltage	250
Number of buttons	2
Number of modules (module system)	0
Min. depth of built-in installation box	0
Built-in depth	0 mm
Built-in height	70.2
Built-in width	70.2
Connection type	Plug clamp
Depth of device	41.7
Height of device	70.2
Width of device	70.2
Mechanical controllable
Electronic controllable
Halogen free
Transparent
Label space/information surface
For awnings
For roller blinds
IFTTT support available

Blind series button with imprinted arrow symbol AP W.1, gray. Blind series button with imprinted arrow symbol AP, with mechanical and electrical locking to prevent switching on from both sides, with plug-in terminals, with an entry for 2 cables and an entry for cable or pipe, full-surface seal under the housing base to seal the rear of the housing, easily accessible, funnel-shaped mounting holes in the housing, a Wago 2-wire connection terminal for wiring included, two snap-in locations for Wago 2-wire connection terminals in the housing base, plenty of space for wiring under the bases of the inserts (hollow base), easy installation of the insert in the housing by snapping it into place, secure fixing of the frame to the housing using a bayonet quick-release fastener. Observe the motor manufacturer's instructions. Housing screws made of stainless steel. Surface-mounted installation. Material: plastic, thermoplastic, impact-resistant.