General
Assembly arrangement	Basic element with complete housing
Model	Single push button
Method of operation	Rocker
Number of poles	1
Number of rockers	1
Number of modules (module system)	0
Mounting method	Surface mounted (plaster)
Type of fastening	Screw mounting
Material	Plastic
Material quality	Thermoplastic
Surface protection	Untreated
Surface finishing	Matt
Colour	Grey
RAL-number (akin)	7011
Imprint	None
Suitable for degree of protection (IP)	IP55
Nominal voltage	250
Rated current	10 A
Width of device	76 mm
Height of device	76 mm
Depth of device	63
Min. depth of built-in installation box	0
Connection type	Plug clamp
Impact strength	IK05
Number of contacts as normally closed contact	1
Number of contacts as normally open contact	1
Operating principle	Electromechanical
Feedback-signal contact
With lighting
Halogen free
Antibacterial treatment
Transparent
Label space/information surface
With signal lamp
IFTTT support available
With light source

Button, normally open AP W.1 gray. Button normally open AP, IP55, with plug-in terminals, with one entry for 2 cables and one entry for cable or pipe, full-surface seal under the housing base to seal the rear of the housing, easily accessible, funnel-shaped mounting holes in the housing, a Wago 2-wire connection terminal for wiring included, two snap-in locations for Wago 2-wire connection terminals in the housing base, plenty of space for wiring under the bases of the inserts (hollow base), easy installation of the insert in the housing by snapping it into place, secure fixing of the frame to the housing via bayonet quick-release fastener, housing screws made of stainless steel. Surface-mounted installation. Material: plastic, thermoplastic, impact-resistant.