Our IO-Link sensor/actuator hubs BNI, with their robust housing, are ideal for use in harsh industrial environments. The I/O modules are based on M12 or M8 connectors and are easy and cost-effective to install and maintain. The port-specific single-channel monitoring detects short circuits and overloads as well as cable breaks at the port. This level of selective diagnostics is unique among I/O modules. Our various variants of sensor/actuator hubs BNI offer the highest functionality with the best flexibility. These product families offer variants for digital inputs/outputs and for analog input signals. Choose the right device according to your needs and requirements. Depending on the application, you can manage up to 16 digital inputs and outputs (with or without a separate power supply for high loads) or up to 8 analog signals. Depending on the area of application, we offer different housing designs, including plastic and metal. As well as different IP protection classes. Interface = IO-Link 1.1, Operating voltage Ub = 18...30.2 VDC, Connection (COM 1) = M12x1 plug, 4-pin, A-coded, Connection (power supply IN) = M12x1 plug, 5-pin, L-coded, Connection slots = 8x M12x1 socket, 5-pin, A-coded, Digital inputs = 16x PNP/NPN, Type 1, Type 3, Digital outputs = 16x PNP, Inputs/outputs configurable = yes, Expansion port = yes, Single channel monitoring = yes, Additional function = Vibration detection, Internal temperature, Device detection, Total current US, Sensor = 2 A, Total current UA, Actuator = 16 A, Switching current = 12x 2 A, 4x 4 A, Housing material = PPS, Dimensions = 68 x 31.8 x 183.5 mm, ambient temperature = -25...70 °C, protection class = IP68, IP69K, screwed state, transmission rate = COM3 (230.4 kBaud), process data cycle min. = 2 ms, process data IN = 12 bytes, process data OUT = 2 bytes, secondary features = identification, device detection, signal delay, signal speed monitoring, switching counter, operating hours counter, start cycle counter, voltage and current monitoring, status of extreme environmental conditions, variant configuration, secondary features for condition monitoring = vibration monitoring, internal temperature monitoring