WIRELESS INTERNET ACCESS!
Do you want to add a WiFi interface to your devices? Get the MKR WIFI 1010! It easily interfaces with other Arduino products and is configurable using Arduino software - and you don't need to be a networking expert. This is the latest version of the MKR 1000 WIFI, but with an ESP32 module from U-BLOX on board.
Arduino® MKR WiFi 1010
The MKR WIFI 1010 is a significant improvement over the MKR 1000 WIFI. It is equipped with an ESP32 module from U-BLOX. This board aims to accelerate and simplify the prototyping of WiFi-based IoT applications thanks to the flexibility of the ESP32 module and its low power consumption.
Technical specificationsMicrocontroller SAMD21 Cortex-M0+ 32bit Low Power ARM MCU Board Power Supply (USB/VIN) 5V Supported Battery(*) Li-Po Single Cell, 3.7V, 700mAh Minimum Circuit Operating Voltage 3.3V Digital I/O Pins 8 PWM Pins 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19) UART 1 SPI 1 I2C 1 I2S 1 Connectivity WiFi Analog Input Pins 7 (ADC 8/ 10/12 bit) Analog Output Pins 1 (DAC 10 bit) External Interrupts 8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17) DC Current per I/O Pin 7 mA Flash Memory 256 KB SRAM 32 KB EEPROM No Clock Speed 32,768 kHz (RTC), 48 MHz LED_BUILTIN 6 Full-Speed USB Device and Embedded Host Included LED_BUILTIN 6 Length 61.5 mm Width 25 mm Weight 32 gr.