The compact Super-Speed ALL-NC 2.5G USBC/A adapter provides seamless conversion of the USB-C 3.1 Gen 1 port into a high-performance Gigabit Ethernet 10/100/1000/2500 Mbps port.
In addition to an impressive bandwidth of 2.5 gigabit, this network card presents a wide range of functions. These include, among other things, the IPv4/IPv6 checksums, which reduce the CPU load, automatic crossover detection and correction, the possibility of TCP large send offload, various modes to support Wake-on-LAN functions, integration with virtual LANs (VLANs) as well as advanced power management functions.
The adapter enables effortless, automatic installation in modern operating systems starting from Windows 8.1 without requiring an active Internet connection. This gigabit network card significantly expands your computer's networking capabilities. It supplements missing RJ-45 network ports or other network cards and even replaces outdated or no longer functioning network connections.
With support for the latest versions of Windows, Mac OS The USB-C connector on the network card is also equipped with an adapter from USB-A to USB-C. This gives you the flexibility to use the network card on both a USB Type-C and a USB Type-A port. Technical Details: Input: Interface USB 3.1 gen 1 / USB 3.0, backward compatible with USB 2.0 and USB 1.1. Connecting USB Type C male connector on a 30 cm long cable permanently attached to the adapter Output: 2.5 Gigabit Ethernet interface with RJ-45 connector for UTP or STP cable connection. Supported transmission rates for the Ethernet interface 10/100/1000/2500 Mb/s. Supported IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX, IEEE 802.3ab 1000Base-T specifications. 10/100/1000 Mbps auto detection. Supports IPv4 / IPv6 packet Checksum Offload Engine (COE) to reduce processor load, including IPv4 IP/TCP/UDP/ICMP/ IGMP < IPv6 TCP/UDP/ICMPv6 checksum control and generation. Supports TCP Large Send Offload V1 and V2. Supports IEEE 802.1P Layer 2 priority encoding < decoding. Supports IEEE 802.1Q VLAN tagging. Supports IEEE 802.3az EEE (Energy Efficient Ethernet) - reduce power consumption at rest. Supports Jumbo frame. Supports full-duplex transmissions with IEEE 802.3x flow control and half-duplex transmissions with back-pressure flow control. Supports Auto MDI/MDIX - crossover detection and auto-correction eliminates the need for crossover cables. Other features: Full Plug and Play and Hot Plug support. Supports CDC-ECM – for automatic installation of drivers across different OSs. Adapter power supply via USB (bus power) - no auxiliary power supply required. Three LEDs: Green - Network link / Yellow - Data Activity / White - Power. Dimensions 61 x 23 x 17 mm, USB cable length 30 cm. Supports Wake-on-LAN feature in different modes: Supports sleep mode and remote Wake Up via Magic Packet, Microsoft Wakeup Frame, Microsoft Wake Packet Detection and Link Change Wake-up. Supports ECMA-393 proxZzzy® standard for sleeping hosts to manage the network connection of sleeping guests using proxy servers. RealWoW! technology support allows remote wake up over the Internet. Supported OSs: MS Windows XP / Vista / 7 / 8 / 8.1 / 10 and later, Windows Server 2003 / 2008 / 2012 / 2016 and later (supported are all 32 and 64-bit versions of Windows OSs), MacOS X 10.6 and higher , Linux with kernel 2.6.14 and above, Android most versions (WARNING - check with the Android device manufacturer if the Ethernet connection is supported).